1. Join the Mud Bogging Community

    If you have any problems with the registration process or your account login, please contact us.

    Please consider registering. It takes 30 seconds, and will allow you to get the most out of the forum.

1979 chevy 3/4 ton 4x4 lifted

Discussion in 'Other Trucks and vehicles' started by blm1984, Jan 1, 2010.

  1. blm1984

    blm1984 New Member

    Credit:
    $0.00
    1979 chevy 3/4 ton 4x4 short bed this is a factory 3/4 ton truck not a half ton truck with 3/4 ton axles. the truck has 12 in. super lift lift kit, and 39.5-15x16.5 super swamper with over 80% tread on 16.5x12 micky tomson wheels. truck has 14 bolt rear with ladder bars and 10 bolt front both have 4.11 gears. this is a four speed truck with 205 gear drive case truck has both drive shalfs in it. some with this much lift do not have front but this one does and it works great. truck has new paint, new headlight doors, side morriors, and tail light lens. truck has a snorke hood scoop form harwood the hood is open under it to clear tunnel ram that the motor that was in it had on it. this truck does not have a motor in it but that is all it needs to be put back on the road.if you figure up the parts this is a buy lift kit runs 1600.00 steering arm 53.62 steering block 53.66 drag link 122.80 tires are 401.00 a piece wheels 170.00 good axles run around 700.00 trans and case around 400.00 for a total of $5214.00 and you still dont have a body and you get the hole truck here for $3500.00 truck is in rome ga.
    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    Attached Files:

  2. georgiaboy27

    georgiaboy27 Active Member

    Credit:
    $0.00
    good salesman!!!! Bump for a good lookin truck!
  3. 85 Silverado

    85 Silverado Active Member

    Credit:
    $0.00
  4. blm1984

    blm1984 New Member

    Credit:
    $0.00

Share This Page